American Standard 7193.803 User manual

Type
User manual
G41
© 2008 AS America Inc.
LAKELAND™ 33" LARGE SINGLE BOWL
KITCHEN SINK
Americast
®
brand engineered material
Single bowl design
• Titanium enamel - heat resistant up to 1000°
Acid-resisting glossy porcelain nish
Top mount or undercounter installation
Silicone sealant supplied
Available in 0, 1, 3, 4 or 5 faucet
hole conguration
Customized Hole Punching Available
(See Holes page G56)
Top Mount/Undercounter:
7193.000 No Holes
7193.001 1 Center Hole
7193.803 3 Holes
7193.804 4 Holes
7193.805 5 Holes
Undercounter Installation Order:
791123-100 Mounting Kit (consists of
cut-out templates and mounting clips)
Nominal Dimensions:
838 x 559 x 241mm
(33" x 22" x 9-1/2")
Bowl sizes:
679mm (26-3/4") wide
413mm (16-1/4") front to back
229mm (9") deep
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.4M for Americast Plumbing Fixtures
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
* See faucet section for available models
To Be Specied:
Color:
Faucet*:
Faucet Finish:
Basket Strainer: 4331.013
Trap:
Optional Accessories:
Basin: 8193.300.365
Bottom Sink Rack: 8193.120.075
Bamboo Cutting Board: 8193.200.090
Dish Rack with Two Utensil Holders and
Colander Kit: 8193.400.075
Under Cabinet Storage: 8193.140.075
LAKELAND™ 33"
LARGE SINGLE BOWL SINK
AMERICAST
®
SEE REVERSE SIDE FOR ROUGHING-IN DIMENSIONS
Revised 2/08
Shown with 4114.100 Lakeland Pull-Out
Kitchen Faucet
G42
© 2008 AS America Inc.
7193.001/803/4/5 Top Mount
7193.001/803/4/5 Undercounter Mount
NOTES:
*
COUNTERTOP CUTOUT for NEW INSTALLATIONS
756mm X 527mm with 25mm Radius
(29-3/4" X 20-3/4" WITH 1" RADIUS)
*
COUNTERTOP CUTOUT for REPLACEMENT INSTALLATIONS
756mm to 806mm X 527mm with 25mm Radius
(29-3/4" to 31-3/4" X 20-3/4" WITH 1" RADIUS)
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL AND
COUNTERTOP SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ASME Standard A112.19.4
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided leaet.
FINISHED FLOOR
36" (914mm)
TO FINISHED
FLOOR (OPTIONAL)
COUNTERTOP
BY OTHERS
SEALING
COMPOUND
7193.804
(4 HOLES)
FINISHED WALL
OR SPLASHBACK
7193.805
(5 HOLES)
1-1/2"
(38mm)
RAD. TYP.
CUTOUT
NOTE
SPRAY
H C
*
1-1/2" O.D. TAILPIECE
1/2"
(13mm)
5-3/4"
(146mm)
9"
(229mm)
2" (51mm) OPTIONAL
33"
(838mm)
8-1/8"
(206mm)
2-1/8"
(54mm)
16-1/2"
(419mm)
8-3/8"
(213mm)
22"
(559mm)
3-1/2"
(89mm)
DIA.
1-1/2" (38mm)
DIA. HOLES TYP.
4"
(102mm)
4"
(102mm)
4"
(102mm)
4"
(102mm)
DETAIL OF MOUNTING CLIP
(KIT No.791123-100)
BRASS
INSERT
13mm
(1/2)
MIN.
REFER TO INSTRUCTIONS
PROVIDED WITH KIT FOR
ADDITIONAL INFORMATION
CLIP
MACH.
SCREW
SINK
FINISHED FLOOR
COUNTERTOP
BY OTHERS
SEALING
COMPOUND
7193.804
(4 HOLES)
FINISHED WALL
OR SPLASHBACK
7193.805
(5 HOLES)
CUTOUT
NOTE
SPRAY
*
H C
MOUNTING CLIP
(SEE DETAIL)
36" (914mm)
TO FINISHED
FLOOR (OPTIONAL)
1-1/2"
(38mm)
RAD. TYP.
1-1/2" O.D. TAILPIECE
1/2"
(13mm)
5-3/4"
(146mm)
2" (51mm) OPTIONAL
33"
(838mm)
8-1/8"
(206mm)
2-1/8"
(54mm)
16-1/2"
(419mm)
8-3/8"
(213mm)
22"
(559mm)
3-1/2"
(89mm)
DIA.
1-1/2" (38mm)
DIA. HOLES TYP.
4"
(102mm)
4"
(102mm)
4"
(102mm)
4"
(102mm)
9-1/2"
(241mm)
NOTES:
Recommended minimum countertop thickness:
Wood - 19mm (3/4")
Marble and Solid Surface - 12mm (1/2")
*
TEMPLATE PROVIDED WITH MOUNTING KIT 791123-100 FOR
UNDERCOUNTER, INSTALLATION AND COUNTERTOP CUTOUT.
FITTINGS AND UNDERCOUNTER MOUNTING KIT NOT INCLUDED
AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL WALL AND
COUNTERTOP SUPPORTS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ASME Standard A112.19.4
These measurements are subject to change or cancellation. No responsibility
is assumed for use of superseded or voided leaet.
LAKELAND™ 33"
LARGE SINGLE BOWL SINK
AMERICAST
®
Revised 2/08
  • Page 1 1
  • Page 2 2

American Standard 7193.803 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI