5019 318 33121
AKR 420-421-425
AKR 436-438-720
I
PRODUCT SHEET
D F NL E
P GRGB
1. Control panel.
2. Grease filters/grease filter grid.
3. Lighting unit.
4. Pull-out steam deflector.
5. Halogen bulbs (AKR 720 only).
Removing and renewing or washing the
grease filter:
1. Disconnect the electrical power supply.
2. Pull out the steam deflector (Fig. 1,a).
3. Open the extractor grille (Fig.1, b-c-d) or remove the
grease filter (Fig. 1, m1-m2).
4. Remove the device securing the grease filter (Fig. 2, e).
5. Remove the dirty grease filter.
6. After the grease filter has been replaced or cleaned
(depending on model), refit the parts in reverse order,
making sure the entire extraction surface is covered.
Fitting or renewing the activated
carbon filter:
1. Disconnect the electrical power supply.
2. Pull out the steam deflector (Fig. 1,a).
3. Open the extractor grille or remove the grease filter.
4. Fitting (Fig. 3): Fit the active carbon filter over the
extraction grill, the arrow (g) printed on the carbon
filter should align with the arrow on the fan shroud (h).
Turn clockwise (i) until the tongue covers the hole, then
insert the pin in the hole to lock the filter.
Removing: Pull the filter tongue downward to unlock it
and turn the active carbon filter anti-clockwise to
release it from its seat.
5. Refit the extractor grille or grease filter.
Replacing bulbs
1. Disconnect the electrical power supply.
2. Pull out the steam deflector (Fig. 1,a).
3. Open the extractor grille or remove the grease filter.
4. Remove the burnt-out bulb.
5. Use 40 W max E14 bulbs (AKR 420-AKR 425) or 20 W
max GU5.3 halogen bulbs only.
6. Refit the extractor grille or grease filter.
CONTROL PANEL
(Switches or Buttons)
Light Switch/Button
The switch/button has two positions.
To switch on the lights: move the switch to the right
(model with switches) or press the button (model with
buttons).
Extraction speed selection Switch/Buttons
There are different extraction speed settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the switch, or
next button to the right.
Fig. 3
Fig. 2
Fig. 1
AKR 438
31833121.fm Page 6 Monday, March 8, 2004 4:22 PM