$.*
$.5
1.
Control panel.
2.
Grease filters (inside extractor grille).
3.
Lighting unit.
4.
Pull-out steam deflector.
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grille.
4.
Remove the grease filter fixing device.
5.
Remove the dirty grease filter.
6.
After renewing (for paper grease filters) or
cleaning (for metal grease filters) the grease
filter repeat the above steps in reverse to
reassemble, making sure the entire
extraction surface is covered.
MOUNTING OR RENEWING THE
CARBON FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Remove the extractor grille.
4.
If a carbon filter is already mounted and
needs renewing, press the release buttons
(
b
) and pull the filter out downwards.
5.
If the filters are not mounted:
a.
fit the carbon filter into the upper clips.
b.
fasten using the lower clips.
6.
Remount the extractor grille.
RENEWING BULBS:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull out the steam deflector.
3.
Open the rear extractor grille.
4.
Remove the burnt-out bulb and insert a new
one. Use 40W max (E14) bulbs only.
5.
Remount the extractor grille.
CONTROL PANEL
A.
Light switch.
B.
Speed selector.
2
3
4
1
O123
4
OI
large amount of steam
and fumes
medium amount of steam
and fumes
BA
Õ
small amount of steam and fumes
PRODUCT DESCRIPTION SHEET
F NL E PGBD GRI