DALI Single Color Touch Controller 09.230TD.04066
Brightness slide
DALI Master/
DALI Master software
via computer
Function introduction
Important: Read All Instructions Prior to Installation
19.4 mm
60.3 mm
DALI Wall
Panel Controller
Front side
Back side
52.0 mm
60.3 mm
52.0 mm
Wiring diagram
12-24VDC
PSU AC 100-240V
Output Signal DALI signal
Power Supply 12-24VDC
Power consumption 200 mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 86x86x29.1mm
Product Data
012
3
4
5
6
7
89
012
3
4
5
6
7
89
(x10)
(x1)
D1 D2V+V-
DC Power input
DALI signal output
DALI Wall
Pane l Controlle r
012
3
4
5
6
7
89
012
3
4
5
6
7
89
(x10)
(x1)
D1 D2V+V-
123
4
GND
AC Power
50/60Hz
L
N
G
V+
V-
OUTPUT
INPUT
12V/24V/36V
CV PSU
123
4
GND
V+ V+
1- V-
2- V-
3- V-
4- V-
Connect with Single Color LED Strip
V+ V+
1- V-
2- V-
3- V-
4- V-
Connect with Single Color LED Strip
Scene button, press and
hold down to save a
scene, click to recall
4 light zones, click to
select, press and hold
down to turn ON/OFF
ON/OFF button
1*(0~9) for setting
units position
10*(0~9) for setting
tens position
Rotary switches for setting start DALI address number (0-63),
the number equals to tens position plus units position
• DO NOT install with power applied to device.
• DO NOT expose the device to moisture.
Safety & Warnings
• Touch sensitive.
• Glass interface(white & black).
• Comply to DALI standard protocol IEC 62386-102, IEC
62386-207 and in compliance with DALI products from
other international incorporation
• 4 light zones are available for switch and dimming
control, each zone can control 1 DALI address.
• Enable to set start DALI address number (0-63) for the 4
zones by rotary switches on the back.
• Enable to save 3 scenes
Installation
12-24VDC
Power Supply
Operation
Set start DALI address number for the zones by rotary switches on the back:
Set the number as X (0-63):
Zone number Z1 will control DALI address X,
Zone number Z2 will control DALI address X+1,
Zone number Z3 will control DALI address X+2,
Zone number Z4 will control DALI address X+3,
Note: if X is set as 63, zone 1 will control DALI address 63, zone 2 will control address 00, zone 3 will control
address 01, zone 4 will control address 02.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Sunricher SR-2400TS User manual
-
-
-
-
-
-
-
-
-
Other documents
-
WAGO 753-647 User manual
-
ABB i-bus KNX User manual
-
-
Legrand DMX Dali Gateway Installation guide
-
-
-
PXM PX787 User manual
-
-
-
CARLO GAVAZZI SBBADT8CCT Owner's manual