Sunricher SR-2300TR-RGBW-EU-DT6 User manual

  • Hello! I've reviewed the user manual for the Sunricher Touch Controller 09.230TC6.04068. This document details how to set up and use the DALI RGBW touch controller, including instructions on setting the DALI address, using the touch interface for scene saving and color control, and general safety guidelines. Feel free to ask me any questions you have about controller.
  • What is the power supply for the controller?
    How many DALI addresses can each zone control?
    How can I save a scene?
    How do I set the DALI address?
    What is the operating temperature range?
DALI RGBW Touch Controller 09.230TC6.04068
Function introduction
Important: Read All Instructions Prior to Installation
Front side
Back side
Wiring diagram
Product Data
DO NOT install with power applied to device.
DO NOT expose the device to moisture.
Safety & Warnings
DALI Wall
Panel Contr oller
012
3
4
5
6
7
89
012
3
4
5
6
7
89
(x10)
(x1)
D1 D2
ON/OFF button
RGB color wheel
012
3
4
5
6
7
89
012
3
4
5
6
7
89
(x10 )
(x1)
19.4 mm
60.3 mm
DALI Wall
Panel Controller
52.0 mm
60.3 mm
52.0 mm
D1 D2
DALI signal output
D2 D1
1*(0~9) for setting
units position
10*(0~9) for setting
tens position
DALI BUS
D1
D2
86x86x29.1mm
Output DALI signal
Operation Current 4mA
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions
Power Supply Supply By DALI Bus
D2 D1
Waterproof grade Ip20
Scene button, press and hold down
to save a scene, click to recall
Brightness button, press
and hold down to
increase/decrease light
intensity
Play/Pause button, click
to play/pause running
effects, press and hold
down to speed up/down
R, G, B, W channel, click to turn ON/OFF, press and hold
down to increase/decrease light intensity
Rotary switches for setting start DALI address number (0-63),
the number equals to tens position plus units position
123
4
GND
AC Power
50/60Hz
L
N
G
V+
V-
OUTPUT
INPUT
12V/24V/36V
CV PSU
Connect wi th R GBW LED Strip
V+ V+
R- R-
G- G-
B- B-
W- W-
Connect wi th R GBW LED Strip
V+ V+
R- R-
G- G-
B- B-
W- W-
123
4
GND
LED indicator
• Touch sensitive.
• Glass interface (white & black).
• Comply to DALI standard protocol IEC 62386-102, IEC
62386-207 and in compliance with DALI products from
other international incorporation.
• 1 light zone is available for switch, dimming and RGB
color control, each zone can control 4 DALI addresses.
• Enable to set start DALI address number (0-63) for the 4
zones by rotary switches on the back.
• Enable to save 4 scenes
• Built-in 8 Color Sequences
Installation
Operation
Set start DALI address number for the light zone by rotary switches on the back:
Set the number as X (0-63), the light zone will control DALI addresses X, X+1, X+2 and X+3.
Note: if X is set as 63, the zone will control DALI address 63, 00, 01 and 02.
/