Sunricher SR-2300TS-RGB-DT6 User manual

Brand: Sunricher

Model: SR-2300TS-RGB-DT6

Type: User manual

DALI RGB Touch Controller 09.230SR6.04067

RGB color slider

Function introduction

Important: Read All Instructions Prior to Installation

19.4 mm

60.3 mm

DALI Wall

Panel Controller

Front side

Back side

52.0 mm

60.3 mm

52.0 mm

Wiring diagram

Output Signal DALI signal

Power Supply 12-24VDC

Power consumption 200 mA

Operating temperature 0-40°C

Relative humidity 8% to 80%

Dimensions 86x86x29.1mm

Product Data

012

(x10)

(x1)

D1 D2V+V-

DC Power input

DALI signal output

ON/OFF button

DALI Master/

DALI Master software

via computer

12-24VDC

PSU AC 100-240V

DALI Wall

Panel Contr oller

012

(x10)

(x1)

D1 D2V+V-

123

GND

AC Power

50/60Hz

V+

V-

OUTPUT

INPU T

12V/24V/36V

CV PSU

Connect with RGB LED S tr ip

V+ V+

R- R-

G- G-

B- B-

Connect with RGB LED S tr ip

V+ V+

R- R-

G- G-

B- B-

123

GND

4 light zones, click to

select, press and hold

down to turn ON/OFF

Scene button, press and

hold down to save a

scene, click to recall

Play/Pause button, click

to play/pause running

effects, press and hold

down to speed up/down

RGB brightness button,

press and hold down to

increase/decrease light

intensity

1*(0~9) for setting

units position

10*(0~9) for setting

tens position

Rotary switches for setting start DALI address number (0-63),

the number equals to tens position plus units position

• DO NOT install with power applied to device.

• DO NOT expose the device to moisture.

Safety & Warnings

• Touch sensitive.

• Glass interface(white & black).

• Comply to DALI standard protocol IEC 62386-102, IEC

62386-207 and in compliance with DALI products from

other international incorporation.

• 4 light zones are available for switch, dimming and RGB

color control, each zone can control 3 DALI addresses.

• Enable to set start DALI address number (0-63) for the 4

zones by rotary switches on the back.

• Enable to save 1 scene for each light zone

• Built-in 8 Color Sequences

Installation

12-24VDC

Power Supply

Operation

Set start DALI address number for the zones by rotary switches on the back:

Set the number as X (0-63):

Zone number Z1 will control DALI addresses X, X+1 and X+2,

Zone number Z2 will control DALI addresses X+3, X+4 and X+5,

Zone number Z3 will control DALI addresses X+6, X+7 and X+8,

Zone number Z4 will control DALI addresses X+9, X+10 and X+11,

Note: if X is set as 63, zone 1 will control DALI address 63, 00 and 01, zone 2 will control address 02, 03 and 04,

zone 3 will control address 05, 06 and 07, zone 4 will control address 08, 09 and 10.

Sunricher SR-2300TS-RGB-DT6 User manual

Sunricher SR-2300TS-RGB-DT6 User manual

Sunricher SR-2300TS-RGB-DT6 User manual

Related papers

Other documents