BF 50 / BD-Blue 130

Parts for Motor Controlled Shutter

Mounting Guide

604480 • 2021-12-01 435525

BF 50 / BD-Blue 130

2 435525 Mounting Guide

1 Mounting guide

BF 50 / BD-Blue 130 parts for motor controlled shutters are used for spare parts and for retrofitting motor con-

troller shutters.

Drill kit

Combination spanner kit

Socket wrench set

BF 50 / BD-Blue 130

Mounting Guide 435525 3

1.2 Mounting the vertical center pillar

Place the vertical center pillar in the fan duct.

Mount 3 screws PT 6x20 TX30 in the top (do not

tighten to more than 2 Nm).

Mount 3 screws PT 6x20 TX30 in the bottom (do not

ing the 3 6x20 screws provided (do not tighten to more

than 2 Nm).

BF 50 / BD-Blue 130

4 435525 Mounting Guide

1.4 Mounting the rotation lock

Mount rotation lock and actuator link with a M6 screw,

2 washers and a M6 lock nut.

towards the rotation lock.

Mount rotation lock and actuator link on the center pil-

lar with a M8 screw, 2 washers and a M8 lock nut.

BF 50 / BD-Blue 130

Mounting Guide 435525 5

1.5 Mounting the shutter plates

the hexagon part towards the fan duct.

BF 50 / BD-Blue 130

6 435525 Mounting Guide

First mount the shutter plates in the bottom and then in

the top.

The shutter plates must go over the holes in the center

Fix the 6 shutter plates to the center pillar with 6 pins

for shutter.

BF 50 / BD-Blue 130

Mounting Guide 435525 7

1.6 Mounting the shutter bracket

more than 2 Nm).

1.7 Mounting the shutter link

Mount 3 shutter brackets on each of the 2 shutter links

BF 50 / BD-Blue 130

8 435525 Mounting Guide

1.8 Mounting the link

actuator pin.

Mount the actuator on the actuator link with an actuator

BF 50 / BD-Blue 130

Mounting Guide 435525 9

1.10 Mounting the blanking plugs

1.11 Cabling

Lead the cable from the actuator through the cable

clamp on the yellow actuator pin.

Drill a 10 mm hole for the actuator cable opposite the

horizontal center pillar.

Mount the actuator cable on the center pillar using 3

cable ties.