KLUS PLD-10-WP User manual

PLD-10-WP
Brand
KLUS
Model
PLD-10-WP
Type
User manual
*The full range of accessories and electronics is available at www.KlusDesign.eu
www.KlusDesign.eu
NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at www.KlusDesign.eu.
Drawings of extrusions and accessories in these instructions are simplied and only
approximate the actual shapes.
1
PLD-10-WP Fastener – mounting instructions
1. PLD-10-WP Fastener (ref. 42292)
2. Rod*
3. Wall fastener*
4. Power supply (12 V / 24 V)*
5. Lighting xture*
1.
2.
3.
4.
5.
CLICK!
www.KlusDesign.eu 2
PLD-10-WP Fastener – mounting instructions
The lighting xture can be rotated
in the mounting brackets.
Mount the fasteners (1) on the rods (2)
and on the wall fasteners (3).
Connect the lighting xture (5)
to the 12 V / 24 V power supply (4)
and snap it in the fasteners.
It is recommended to use:
2 fasteners for 1 m of xture
4 fasteners for 2 m of xture
5 fasteners for 3 m of xture
I
II
III
5.
1.
2.
3.
4.
1.
2.
3.
  • Page 1 1
  • Page 2 2

KLUS PLD-10-WP User manual

PLD-10-WP
Brand
KLUS
Model
PLD-10-WP
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents