Tear o the 3M tape on the back of the
side marker lights and route the
electrical harness through the upper
channel.
Next, simply snap it in and press gently
to make sure it's firmly in place as
shown in Figure 4.
STEP 4
Now, please connect the electronic wiring
harness of the side marker lights to the
factory wiring harness separately (Refer to
wiring diagram below).
Then, Power-ON to test and make sure all
signal functions are working properly.
STEP 5
Let’s repeat the same steps on
the Passenger Side.
STEP 6
WIRE
COLOR
6
5
4
3
2
1
BG
BN
WH
GN BK BK
WH
BN
WH
YE
Function Side
Marker Turn Ground GroundParking DRL
1 2 3 4 5 6
TAPE