Skov Start current limiter Technical User Guide

I have carefully reviewed the installation guide for the SKOV Start Current Limiter BF 50. This document provides all the necessary steps for installing the start current limiter kit, including electrical connections and safety precautions. I am happy to answer any questions you may have about this device.
What is the purpose of the start current limiter kit?

Who should perform the installation of the kit?

What components are used for the electrical connection?

604479 • 2021-11-12 560393

Start Current Limiter for BF 50 Shutter ON/OFF

Installation guide

Start current limiter kit is used to limit the start current to BF 50 shutter ON/OFF.

Electrical connection

Installation, servicing and troubleshooting of all electrical equipment must be carried out by quali-

fied personnel in compliance with the applicable national and international standard EN 60204-1

and any other EU standards that are applicable in Europe.

The installation of a power supply isolator is required for each motor and power supply to facili-

tate voltage-free work on the electrical equipment. The power supply isolator is not included.

Connection of the components (A)+(C) in all BF 50 ON/OFF actuator

control boxes

1. Disconnect the 230 V supply.

2. Disconnect the red wire in the 24 V terminal.

3. Connect the black component (A) in terminal 24 V.

4. Connect wire to the black component (A) with splicing sleeve (B) (orange WAGO 221).

5. Nothing must be connected in terminal (C).

6. Reconnect the 230 V supply and check that the actuators can open the shutters.

SKOV A/S • Hedelund 4 • Glyngøre • DK-7870 Roslev

Tel. +45 72 17 55 55 • www.skov.com • E-mail: [email protected]

604479 • 2021-11-12 • en-US • Made in Denmark