1 Installation of SpeedUp Wall Heating in Dry Wall Installations
Fig. 1: To attach the individual system elements use material
compatible adhesive such as for example foam insulation (PU).
Fig. 2: In accordance with the layout drawing start with header
or edge panels.
Fig. 3: The heating panels must be laid horizontally – with the
supply point at the bottom.
Fig. 4: The predetermined breaking points mean that the
system elements can easily be shortened both longitudinally
and laterally.
Fig. 5: Fill boundary areas or areas for electrical installations
with blank panels.
Fig. 6: Direct the return flow from above to the connection
pipe using separated CZ (pipe spacing 25 cm) or EZ panels
(pipe spacing 12.5 cm).
Installation Guide
SpeedUp Wall Heating in Dry Wall Installations
Danfoss Heating Solutions VIETB202
1
Fig. 7: Cut out individual pipe channels with the hot wire cutter
ensuring that the correct angle of arc is used.
Fig. 8: Press the composite pipe in a loop into the channels
(connection: see distributor instructions).
Fig. 9: Always make the pipe couplings between the straight
aluminium sheet - not in the bends.
Fig. 10: Use 12.5 fibre reinforced plasterboard for panelling,
attachment and sealing according to manufacturer’s
instructions. Seal edge joints with acrylic filler.
Installation Guide
SpeedUp Wall Heating in Dry Wall Installations
Danfoss A/S
Heating Solutions
Haarupvaenget 11
8600 Silkeborg
Denmark
Phone:+45 7488 8000
Fax: +45 7488 8100
Email: [email protected]
www.heating.danfoss.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective
companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
VIETB202 Produced by Danfoss Heating Solutions © 11/2010
/