1 Installation of SpeedUp Eco Strongboard for Carpet and Synthetics
Fig. 1: Once acclimatised for 2-6 days begin installing
Strongboard. Cut perimeter insulation along the edge of the
support battens.
Fig. 2: Cut the tongue that meets the wall side and lay with an
expansion gap of 10 mm using appropriate wedges.
Fig. 3: Use circular saw (universal blade) and utilise rest pieces
of more than 40 cm at the beginning of the next row.
Fig. 4: In larger rooms (more than 8 m length/width) a
movement joint should be installed which should rest on
support battens.
Fig. 5: The Strongboard panels should be laid in a staggered
pattern, allowing at least 40 cm for each laid panel.
Fig. 6: Join the boards using the tongue and groove.
Installation Guide
Danfoss Heating Solutions VICTB302
1
Fig. 7: As the Strongboard system settles the tongue and
groove mechanism clicks into place.
Fig. 8: With a mallet and a wooden block give a gentle tap to
the short ends.
Fig. 9: Seal the floor with a wood sealant immediately after
laying and leave to dry for 12 hours.
Fig. 10: It is possible to lay carpet or a suitable synthetic
product after 10 to 24 hours.
Installation Guide
Danfoss A/S
Heating Solutions
Haarupvaenget 11
8600 Silkeborg
Denmark
Phone:+45 7488 8000
Fax: +45 7488 8100
Email: [email protected]
www.heating.danfoss.com
Danfoss can accept no responsibility for possible errors in catalogues, brochures and other printed material. Danfoss reserves the right to alter its products without notice. This also applies to products
already on order provided that such alterations can be made without subsequential changes being necessary in specifications already agreed. All trademarks in this material are property of the respective
companies. Danfoss and the Danfoss logotype are trademarks of Danfoss A/S. All rights reserved.
VICTB302 Produced by Danfoss Heating Solutions © 01/2011
/
