USE OF THE SELECTION CONTROLS
A
. PROGRAMME SELECTOR KNOB
With this knob you can select the wash programme as you
wish. Press the central knob and then pull out and turn until
the programme (number or symbol) coincides with the marker
point. Having made the selection, press the knob in again.
ALWAYS ROTATE the control in a clockwise direction, never
in an anticlockwise direction. Do not press the “on” button
(H) before selecting the programme
.
If you wish to modify the position of the control or select
another programme once a cycle has commenced, press
the Start/Stop key. Press again to recommence once the
modification has been completed.
B
. TEMPERATURE SELECTOR KNOB
With this knob you can select the washing temperature as
you wish. Press the central knob and then pull out and turn
until the temperature selected coincides with the marker point.
Having made the selection, press the knob in again.
If you wish to carry out a cold wash, turn the knob until the
cold symbol coincides with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
Do not exceed the maximum temperature recommended for
each cycle in the table of programmes.
47
48
T
C
USE OF THE SELECTION CONTROLS
C
. SPIN SPEED SELECTOR KNOB
This control allows you to select the speed of the final spin.
To select a speed, press the centre of the control knob to
release and turn it until the desired speed coincides with the
selector mark. When you have selected a speed, press the
control knob once again.
This knob selects the final spin speed. To select a speed,
press down and turn until the desired speed coincides with
the selector mark.
The final spin cycle reaches the maximum speed selected in
non-delicate programmes. The middle and final spin cycles
for mixed, synthetics and delicate programmes is carried out
at 400 r.p.m.
If you do not want a spin cycle, coincide the spin exclusion
symbol with the selector mark.
THE KNOB CAN BE TURNED IN BOTH DIRECTIONS.
D
. FLOT BUTTON (Anticreasing)
The Flot button only works in programmes (5-6-7-8-9-10) for mixed, synthetic
and very delicate fabrics.
When the button is pressed, the machine stops in the last rinse of these
programmes, leaving the wash soaking with a high water level.
To complete these programmes, spin the wash by pressing the button again to
release it.
E
. SUPER-RINSE BUTTON
Pressing this button removes the last vestiges of soap powder from the
fabrics, as the rinses are done with more water.
F
. SUPER RAPID BUTTON
When this button is pressed the time for the wash programmes of this washing
machine is reduced to a maximum of 50 minutes, according to the wash
programme and temperature selected. The Super Rapid Button can be used
for washes of from 1 to 4.5 kg.
G
. ON/OFF PILOT LIGHT
H
. ON/OFF BUTTON