2. FläktGroup
  3. EQLZ-02 EQBZ-10 Cowl

FläktGroup EQLZ-02 EQBZ-10 Cowl Installation guide

  • Hello! I've reviewed the provided installation instructions for the FläktGroup cowl models EQLZ-02 and EQBZ-10. This document provides a step-by-step guide on how to assemble the cowl, which is not pre-fitted. It uses self-tapping screws for mounting. The instructions cover mounting the top panels and side panels, and also mention how to place the protective screen when fitting the cowl to the fan outlet. Feel free to ask any questions you have about the installation process.
  • Is the cowl pre-fitted at the factory?
    What type of screws are used for installation?
    Where should the cowl top panels be fitted?
FläktGroup DC_8645GB 20180122_R0 We reserve the right to make changes without prior notice
EQLZ-02 COWL (C=2, 3)
EQBZ-10, E=1 COWL FOR OUTDOOR USE
EQLZ-02 (C=2)
LOCATION OF OUTLET
The cowl is not fitted at the factory. Fit the cowl as follows:
Fit the cowl top panels centrally over the protective screen and
secure itwith self-tapping screws as shown.
Secure the cowl side panels to the unit casing and to the top panel
by means of self-tapping screws as shown.
FAN OULET EQLZ-02 (C=3)
If fitted at the fan outlet, place the protective screen centrally across
the fan outlet as shown.
Self-tapping-screws,
(not included in the delivery)
Top panel
Side panels (one right-hand panel
and one left-hand panel)
Protective screen Self-tapping-screws
(not included in the delivery)
COWL
EQLZ-02, EQBZ-10
INSTALLATION INSTRUCTION
/