FläktGroup EUBZ-02 Cowl Installation guide

  • I have analyzed the installation instructions for the Fläkt Woods Cowl EUBZ-02. The document describes how to install the cowl, including the protective screen, top panels, and side panels using self-tapping screws. I'm ready to answer your questions about this installation process.
  • Is the cowl pre-installed at the factory?
    Where is the protective screen placed?
    How are the cowl panels secured?
Fläkt Woods 4068 GB 03.01 1 Specifications are subject to alteration without notice
EU Air Handling Unit INSTALLATION
EUBZ-02 Cowl
Location of outlet
The cowl is not fitted at the factory. Fit the cowl as fol-
lows:
A. If fitted at the fan outlet, place the protective screen
centrally across the fan outlet as shown in Fig. 1.
B. Fit the cowl top panels centrally over the protective
screen and secure it with self-tapping screws as shown
in Fig. 2.
C. Secure the cowl side panels to the unit casing and to
the top panel by means of self-tapping screws as
shown in Fig. 2.
Fig. 1
Fig. 2
Self-tapping-screws
(not included in the delivery)
Top panel
Side panels (one right-hand
panel and one left-hand panel
Protective screen
Self-tapping-screws
(not included in the delivery)
/