MULTIPLEX MD Purge Tube Routing Installation guide

11 Part No. 5030478

Revision 0

Carbonator Tank Purge Tube Routing Instructions for MD Series Units

Routing Instructions

1. During installation of unit the carbonator

tank purge tube (A) must be properly routed

to a drain. Once the splash panel has been

removed from unit remove twist tie (B) that

holds carbonator tank purge tube (See Figure

1).

2. Route carbonator tank purge tube (A) down

front of unit and behind drain pan (See

Figure 2). Be sure not to collapse or kink

carbonator tank purge tube during routing

from unit to drain.

3. The carbonator tank purge tube (A) can be

routed down through the counter top that unit

has been installed on or out the rear of unit.

Then install carbonator tank purge tube to a

drain (See Figure 3). Follow all local and

national plumbing codes when routing

carbonator tank purge tube to the drain.

Figure 1

Figure 2

Drain

Pan

Figure 3

Drai

Rear of Unit

Pressure Relief Valve

Purge tube is connected to

the pressure relief valve on

carbonator tank and must

be routed to a drain