2. KLUS
  3. PDS-STN-ALFA
PDS-STN-ALFA

KLUS PDS-STN-ALFA User manual

  • Hello! I've reviewed the mounting instructions for the KLUS PDS-STN-ALFA Mounting bracket, Lighting fixture and Power supply. This document outlines two different mounting methods and provides essential information about connecting your LED lighting to a 12V or 24V power supply. I'm here to assist with any questions you might have regarding the installation process.
  • What voltage power supply is needed for the LED tapes?
    Where can I find additional mounting procedures and accessories?
    Are the drawings accurate?
*The full range of accessories and electronics is available at www.KlusDesign.eu
www.KlusDesign.eu
NOTE! All LED tapes must be connected to a 12 V or 24 V power supply.
IMPORTANT: Not all possible mounting procedures are presented here.
More mounting procedures and related accessories can be found at www.KlusDesign.eu.
Drawings of extrusions and accessories in these instructions are simplied and only
approximate the actual shapes.
1
PDS-STN-ALFA Bracket - mounting instructions
1. PDS-STN-ALFA Mounting bracket (product made to order)
2. Screw*
3. Lighting xture*
4. Power supply (12 V / 24 V)*
P. 2
P. 3
1.
2.
3.
4.
CLICK!
www.KlusDesign.eu 2
PDS-STN-ALFA Bracket - mounting instructions
a) Mounting the xture into mounting brackets screwed to the surface
Feed the power cable from the xture
to the power supply (4).
Snap the lighting xture (3) into the
brackets.
Attach the mounting bracket (1) to the
surface with appropriate screws (2) (not
provided).
Ia
IIa
IIIa
2.
1.
4.
3.
CLICK!
www.KlusDesign.eu 3
PDS-STN-ALFA Bracket - mounting instructions
b) Installation of the xture with brackets mounted on the prole
Feed the power cable from the xture
to the power supply (4).
Attach mounting brackets (1)
to the xture (3).
Attach the xture with brackets to the
surface with appropriate screws (2)
(not provided).
Top view
Ib
IIb
IIIb
3.
1.
4.
2.
/