Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Flat screwdriver
C. Long needle pliers
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove two (2) screws from
the battery cover on the right side of the unit.
Locate and disconnect the charger port connector from the
controller.
VECTOR CHARGER PORT
REPLACEMENT PROCEDURES
PART # W15127016106
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Using a flat screwdriver, remove the glue at the back of
the charger port.
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Using long needle pliers, remove the lock nut from the
back of the charger port and push the charger port out
from the cover.
-
1
-
2
