Razor W20136401003 User manual

Type
User manual
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. 5 mm Allen wrench
B. 4 mm Allen wrench
C. 8 mm wrench
D. Long needle pliers
E. Phillips screwdriver
F. 32 mm wrench or adjustable wrench
G. 10 mm crown wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a 5 mm Allen wrench, loosen the bolts from
the collar clamp. Remove the T-bar from the front fork.
Disconnect brake and throttle wires.
Using a 4 mm Allen wrench and 8 mm wrench, loosen the
bolt that holds the brake cable.
POWER CORE E90 SPRINT FRONT FORK
INSTALLATION INSTRUCTIONS
PART # W13112144023
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Using long needle pliers, remove the end cap from the
brake cable and set aside. Pull the brake cable and
spring.
Using a Phillips screwdriver, remove the two (2) screws
from the limiter bolt cover. Remove limiter bolt.
Step 5
Step 7
Step 6
Using a 32 mm wrench or a large adjustable wrench,
loosen the headset bearing lock nut. Remove headset
bearing lock nut.
Using a 10 mm crown wrench, hold the lock nut from
inside the fork. With a 5 mm Allen wrench, loosen and
remove the limiter bolt. Slide the fork down and replace it.
Reverse the steps.
ATTENTION: Charge battery 12 hours before using.
  • Page 1 1
  • Page 2 2

Razor W20136401003 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI