2. Razor
  3. W13112144015

Razor W13112144015 Operating instructions

  • Hello, I've read the Razor E90 Sprint Controller replacement manual and I'm ready to answer your questions. This document provides a step-by-step guide on how to replace the controller, including the tools you'll need and important safety warnings. Feel free to ask me anything related to the replacement process.
  • What tool is required for the replacement?
    What is the first step in the replacement procedure?
    What should be done before performing any maintenance?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove the five (5) screws
from the side with the power switch.
Pull the cover off. Be careful not to damage the wires for
the charger port and power switch. Set cover aside.
POWER CORE E90 SPRINT CONTROLLER
REPLACEMENT PROCEDURES
PART # W13112144015
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Using a Phillips screwdriver, remove the two (2) screws
that hold the controller onto the frame.
Disconnect all connectors from the controller and remove
the controller.
Step 7
Reverse the procedures
ATTENTION: Charge battery 12 hours before using.
/