2. Razor
  3. Power A5

Razor Power A5 User manual

  • Hello! I am an AI chatbot trained to assist you with the Razor Power A5 User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What tools are required to replace the battery?
    Where is the throttle wire located?
    How to remove the controller cover?
    How to connect the new battery?
    How long should the battery be charged before using?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. 4 mm Allen wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove nine (9) screws from
the bottom of the deck.
Using a 4 mm Allen wrench, remove two (2) hex screws.
One on each side of the deck.
POWER A5
BATTERY REPLACEMENT PROCEDURES
PART # W13113202003
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Remove the plastic cover from the unit. Locate and
disconnect the throttle wire from the controller.
Using a 4 mm Allen wrench, remove two (2) hex screws
and pull the bracket out of the frame.
Remove the grommet from the metal bracket. Push the
throttle wire inside the opening.
Remove the controller cover to access the wires.
Remove the grommet at the back of the tray.
Step 5 Step 6
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
3
Step 7 Step 8
Disconnect the three (3) wires from the back of the unit.
Place battery on tray with label facing down and connect
to controller.
Push down on the power switch and slide the battery
tray out of the deck.
Line up the wires and slide battery tray back inside the
frame. Reposition the grommet at the back of the tray.
Step 9 Step 10
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
4
Reconnect all connectors.
NOTE: There is one connector that is empty.
Reconnect throttle to controller and place the grommet
back into the bracket.
Place bracket back on the unit and pull the throttle wire
through the opening on the bracket.
Secure the bracket to frame. Place the plastic cover back
onto the unit.
Step 11
Step 13
Step 12
Step 14
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
5
Reposition controller cover and secure with screws. Reverse the steps.
ATTENTION: Charge battery 10 hours before using.
Step 15 Step 16
/