2. Razor
  3. Power A5

Razor Power A5 User manual

  • Hello! I'm a chat assistant and I've reviewed the document you provided, which is a user manual for replacing the charger port and power switch on a Razor A5 device. The instructions detail the necessary steps for disassembly and reassembly, including the required tools and safety precautions. I'm here to assist you with any questions you might have about this manual or the replacement process.
  • What tools are required for this procedure?
    What safety precaution should I take before starting?
    How many screws need to be removed from the bottom of the deck?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. 4 mm Allen wrench
C. Flat screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a 4 mm Allen wrench, remove two (2) hex screws.
One on each side of the deck.
Using a Phillips screwdriver, remove nine (9) screws from
the bottom of the deck.
POWER A5
CHARGER PORT - POWER SWITCH
REPLACEMENT PROCEDURES
PART # W13113202106
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Remove the plastic cover from the unit. Locate and
disconnect the throttle wire from the controller.
Using a 4 mm Allen wrench, remove two (2) hex screws
and pull the bracket out of the frame.
Remove the grommet from the metal bracket. Push the
throttle wire inside the opening.
Remove the controller cover to access the wires.
Remove the grommet at the back of the tray.
Step 5 Step 6
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
3
Step 7 Step 8
Disconnect the three (3) wires from the back of the unit.
Once the battery-controller tray is out the deck.
Push down on the power switch and slide the battery
tray out of the deck.
Using flat screwdriver, lift and remove the plastic bracket
that holds the power switch and charger port in place.
Step 9 Step 10
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
4
Remove the silicone around power switch or charger port
and push components out from the tray.
Reverse the steps.
ATTENTION: Charge battery 10 hours before using.
Step 11 Step 12
/