2. Razor
  3. Rambler
Rambler

Razor Rambler User manual

  • Hello! I've analyzed the user manual for the Rambler 16 W15128190106 Charger Port replacement. It outlines a detailed procedure with safety steps, tool requirements, and visual aids for the replacement process. I'm ready to address any questions you might have about the document or the charger port replacement itself.
  • What tools are required for the replacement process?
    What should be done before starting the replacement?
    How many screws need to be removed in Step 1?
    How many screws need to be removed in Step 2?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Small Phillips screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove seven (7) screws
from the side of the battery cover with the power switch.
Remove four (4) screws, two (2) at the front and two (2) at
the back of the battery cover. Pull the cover out. Be careful
not to damage the wires.
RAMBLER 16 CHARGER PORT
REPLACEMENT PROCEDURE
PART # W15128190106
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Reverse the steps.
ATTENTION: Charge battery 12 hours before using.
Locate and disconnect the charger port from the
controller.
Using a small Phillips screwdriver, remove the two (2)
screws that hold the charger port onto the battery cover.
Pull the charger port out from the battery cover.
/