2. Razor
  3. W15127016106
W15127016106

Razor W15127016106 User manual

  • Hello! I've reviewed the user manual for the Razor Charger Port W15127016106 replacement. This document provides step-by-step instructions on how to replace the charger port including the tools required, safety instructions, and the order of operations. I'm ready to answer any specific questions about the replacement process or the device.
  • What tools are needed for the charger port replacement?
    What should I do before starting the replacement?
    How many screws should be removed from the battery cover?
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
B. Flat screwdriver
C. Long needle pliers
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove two (2) screws from
the battery cover on the right side of the unit.
Locate and disconnect the charger port connector from the
controller.
VECTOR CHARGER PORT
REPLACEMENT PROCEDURES
PART # W15127016106
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Using a flat screwdriver, remove the glue at the back of
the charger port.
Reverse the steps.
ATTENTION: Charge battery 8 hours before using.
Using long needle pliers, remove the lock nut from the
back of the charger port and push the charger port out
from the cover.
/