Zoroufy Grand Regency Operating instructions

Brand
Zoroufy
Model
Grand Regency
Type
Operating instructions
1)Attach finial to rod by inserting rod into the finial base and tightening the small set screw.
If using a sleeve, See step 6 and then continue with steps 3-5 in order.
2)Slide support bracket onto the rod and attach remaining finial to rod by tightening the
small set screw previously attached to the finial.
3)Locate desired position of support brackets on the wall, making sure the rod is level. A
support bracket should be positioned near both ends of the rod and the remaining support
bracket(s) should be in the center or evenly spaced on the rod if there is more than one center
support.
4)Mark the installation holes of support brackets. Install the support brackets using screws
provided. You must use wall anchors (not included) suitable for your wall material, if screws are
not screwed into a stud.
5) Attach clips to rug or tapestry and hang by placing over the rod. If clips are not being used
and a sleeve is, mark where the brackets are and cut a small slit, vertically allowing the bracket to
show through. Place rug or tapestry on rod and slide carefully through brackets.
Specifications
Finial
Length
Pineapple
3 ¼”
Ball
2 ½ ”
Urn
2 5/8”’
Rod Gauge
.031
Rod Diameter
¾”
Grand Regency™ Wall Hanger
Installation Instructions
Finial measurements vary by
style. Please see chart to left
2140 W. GREENVIEW DR. SUITE 5, MIDDLETON, WI 53562-0345 • 800-762-1525 • [email protected] • www.zoroufy.com
ALL PARTS ARE LACQUER
COATED TO RESIST
TARNISHING. DO NOT USE
BRASS CLEANER OR OTHER
ABRASIVES. TO CLEAN,
SIMPLY WIPE WITH A SOFT
DRY CLOTH.
PERIODICALLY CHECK AND
TIGHTEN ALL SCREWS AND
HARDWARE
  • Page 1 1

Zoroufy Grand Regency Operating instructions

Brand
Zoroufy
Model
Grand Regency
Type
Operating instructions
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents