FINIAL
Pineapple
ALL PARTS ARE LACQUER COATED TO RESIST TARNISHING. DO NOT USE BRASS CLEANER OR OTHER ABRASIVES. TO CLEAN, SIMPLY WIPE WITH A SOFT DRY CLOTH.
PERIODICALLY CHECK AND TIGHTEN ALL SCREWS AND HARDWARE.
SPECIFICATIONS
Legacy
2140 W. GREENVIEW DR. SUITE 5, MIDDLETON, WI 53562-0345 • 800-762-1525 • [email protected] • www.zoroufy.com
1. With finials and end brackets attached to rod,
expand rod to desired length. If using a sleeve or
pocket on the back of the rug, tapestry, or quilt,
separate rods and slide into sleeve or pocket first.
2. Hold rod in desired position against wall and mark
position of holes in the left end bracket.
3. While supporting the ride side, install the left end
bracket using provided screws. Wall anchors must
be used if screws are not installed into a stud.
5. After end brackets are installed, place center support
brackets into desired positions and install. Wall anchors
must be used if screws are not installed into a stud.
6. If using clips, attach to the rug, tapestry, or quilt and
secure in place by tighting the disc. Both 1/2” and 5/8”
are provided and should be used on corresponding
rods. Place clips over the rod.
INSTALLATION INSTRUCTIONS
LENGTH
3 1/4”
Zoroufy® Stair Rods slide into each
bracket approximately ½".
Finials attach to the bracket.
4. Located position of the right end bracket by leveling
rod and expanding to desired length. Install the right
end bracket into wall.
®
ROD GAUGE
ROD DIAMETER
.031”
1/2” into 5/8”
WALL HANGER COLLECTION
1.375”
3.25”
/
