Specifications
Finial Length
Pineapple
Round
Crown
Urn
Acorn
Rod Diameter: 1/2"
1 3/8"
3/4"
1 7/8"
1 1/4"
1 1/4"
1) Remove screws from finials. Align the hole on the
bottom of the finial with the outside hole for both left and
right end brackets. Insert and attach screw so finial and
bracket are tightly connected. Repeat for both end
brackets.
2) Place left end bracket on wall at desired location to be
attached. Position bracket holes on bottom, as shown in
diagram above.
3) Install screws through bracket holes into wall.
4) Slide rod into the installed end bracket. Take the center
bracket and slide over rod. Attach center bracket to wall
in center of rod.
5) Slide right end bracket over right end of rod and attach
to wall with screws.
6) Attach clips by sliding over rod.
1) Remove screws from finials. Align the hole on the bottom
of the finial with the outside hole for both left and right end
brackets. Insert and attach screw so finial and bracket are
tightly connected. Repeat for both end brackets.
2) Place left end bracket on wall at desired location to be
attached. Position bracket holes on bottom, as shown in
diagram above.
3) Install screws through bracket holes into wall.
4) Slide rod into the installed end bracket. Take the center
bracket and slide over rod. Attach center bracket to wall in
center of rod.
5) Place double-wide center support bracket on end of rod.
Insert the rod through half of the bracket. Secure rod by
tightening the small set screw on face of bracket. Repeat
with second rod.
6) Take the last center bracket and slide over rod. Attach
center bracket to wall in center of rod.
7) Slide right end bracket over right end of rod and attach to
wall with screws.
8) Attach clips by sliding over rod.
Classic Wall Hanger
Collection
Installation Instructions
Sets 72" & Under Sets Over 72"
Note: Wall anchors must be used if screws
are not installed into a wall stud.
/
