2. Zoroufy
  3. Classic Wall Hanger Collection

Zoroufy Classic Wall Hanger Collection User manual

  • Hello! I've reviewed the installation instructions for the Classic Wall Hanger. This document provides detailed steps for installing the hanger, including how to attach the end brackets, slide in the rod, and secure the center bracket. There are separate instructions for sets 72" and under and sets over 72". I'm ready to answer any questions you have about the installation process or the wall hanger specifications.
  • What is the rod diameter?
    What should be used if screws are not installed into a wall stud?
    What finial options are available?
Specifications
Finial Length
Pineapple
Round
Crown
Urn
Acorn
Rod Diameter: 1/2"
1 3/8"
3/4"
1 7/8"
1 1/4"
1 1/4"
1) Remove screws from finials. Align the hole on the bottom of the finial
with the outside hole for both left and right end brackets. Insert and attach
screw so finial and bracket are tightly connected. Repeat for both end
brackets.
2) Place left end bracket on wall at desired location to be attached. Position
bracket holes on bottom, as shown in diagram above.
3) Install screws through bracket holes into wall.
4) Slide rod into the installed end bracket. Take the center bracket and
slide over rod. Attach center bracket to wall in center of rod.
5) Slide right end bracket over right end of rod and attach to wall with
screws.
6) Attach clips by sliding over rod.
1) Remove screws from finials. Align the hole on the bottom of the finial with
the outside hole for both left and right end brackets. Insert and attach screw
so finial and bracket are tightly connected. Repeat for both end brackets.
2) Place left end bracket on wall at desired location to be attached. Position
bracket holes on bottom, as shown in diagram above.
3) Install screws through bracket holes into wall.
4) Slide rod into the installed end bracket. Take the center bracket and slide
over rod. Attach center bracket to wall in center of rod.
5) Place double-wide center support bracket on end of rod. Insert the rod
through half of the bracket. Secure rod by tightening the small set screw on
face of bracket. Repeat with second rod.
6) Take the last center bracket and slide over rod. Attach center bracket to
wall in center of rod.
7) Slide right end bracket over right end of rod and attach to wall with screws.
8) Attach clips by sliding over rod.
Classic Wall Hanger
Collection
Installation Instructions
Sets 72" & Under Sets Over 72"
Note: Wall anchors must be used if screws are not installed into a wall stud.
2140 W. GREENVIEW DR. SUITE 5, MIDDLETON, WI 53562-0345 • 800-762-1525 • [email protected] • www.zoroufy.com
/