2. BLOTZ
  3. B28-BS-001

BLOTZ B28-BS-001 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ B28-BS-001 Rowing Boat model. This document provides clear, step-by-step guidance on assembling the model using basic tools and materials, such as PVA glue and a sharp modeling knife. The instructions cover the entire process of the construction, from the base to the final pieces like the rowlocks and the rudder. I'm ready to answer any questions you have about building this model.
  • What kind of glue should I use to assemble this model?
    What tool is needed to remove parts from the sprue?
    What can I use to hold pieces in place while glue dries?
28mm Rowing Boat
B28-BS-001
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Remove the base, the smallest “frame” and the
two inner supports from the sprue.
Glue the frame to the base using the line around the
base to help align it then attach the supports.
Take the other two frames.
Glue them into place as shown above using the
supports to align them.
Take the prow piece, rowlocks and rudder from
the sprue.
Glue them into position.
The completed model
/