S P E C F I L E
ET-PKA110S
Ceiling mount bracket for low ceilings
As of September 2011
SFL11A006
1 / 1
Weights and dimensions shown are approximate. Specifications subject to change without notice.
Attachement
plate
Projector
52.5
(2-1/16 )
154
(6-1/16 )
PT-AE7000/AT5000: 204 (8-1/32)
PT-AR100/AH1000: 220 (8-21/16)
Specifications
Vertical correction angle +5°, -15°
Horizontal slant correction angle ±10°
Horizontal turn correction angle ±5°
Dimensions (W × H × D) 306 × 89.5 × 174 mm
(12-1/16˝ × 3-17/32˝ × 6-7/8˝)
Weight Approx. 1.3 kg* (2.9 lbs*)
Applicable projectors PT-AE7000/AT5000/AR100/AH1000
Attachment plateIllustration shows the ET-PKA110S attached to a projector.
Parts
Attachment plate . . . . . . . . . . . . . . . . . . . . . . 1
Projector mount bracket . . . . . . . . . . . . . . . . 1
Washer-fitted screws (M4 × 10) . . . . . . . . . . . 5
Wire rope for ceiling mount bracket . . . . . . . 1
Flat wire clip for ceiling mount bracket . . . . . 2
Clamp tube for ceiling mount bracket . . . . . . 2
Wire rope for projector unit . . . . . . . . . . . . . . 1
*
Average value. May differ depending on models.
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
Description This ceiling mount bracket is to be used when mounting home cinema projectors to the ceiling.
C a u t i o n :
• All mounting work must be done by a qualified technician.
• Ensure that the mounting (ceiling) area has sufficient strength.
• Read the enclosed mounting instructions carefully before starting the mounting procedure.
• When the system is no longer to be used, have a qualified technician promptly remove and dispose of it.
• Do not use a power screwdriver or impact screwdriver to tighten screws. A torque screwdriver or similar tool
should be used.
3-∅ 9.5 (∅ 3/8)
∅8.5
(∅11/32)
20 (2-9/16)
160 (6-5/16 )
150 (5-29/32)
130 (5-1/8)
104 (4-3/32)
140 (5-1/2)
114 (4-1/2)
25 (31/32)
/
