S P E C F I L E
ET-PKA110H
Ceiling mount bracket for high ceilings
As of September 2011
SFL11A005
1 / 1
Weights and dimensions shown are approximate. Specifications subject to change without notice.
Attachement
plate
Projector
PT-AE7000/AT5000: 214 (8-7/8)
PT-AR100/AH1000: 230 (9-1/16)
62
(2-7/8 )
370.5− 450.5 (14-19/32 –17-3 /4 )
Adjustable in
20 mm (25/32) steps
∅43
(1-11/16)
∅49
(1-15/16)
Specifications
Vertical correction angle +5°, -20°
Horizontal slant correction angle ±10°
Horizontal turn correction angle ±5°
Dimensions (W × H × D) 306 × 306 – 386 × 174 mm
(12-1/16˝ × 12-1/16˝–15-5/16˝ × 6-7/8˝)
Weight Approx. 2.4 kg* (5.3 lbs*)
Applicable projectors PT-AE7000/AT5000/AR100/AH1000
Attachment plateIllustration shows the ET-PKA110H attached to a projector.
Parts
Attachment plate . . . . . . . . . . . . . . . . . . . . . . 1
Projector mount bracket . . . . . . . . . . . . . . . . 1
Adjustment pole A . . . . . . . . . . . . . . . . . . . . . 1
Adjustment pole B . . . . . . . . . . . . . . . . . . . . . 1
Angle adjusting bracket A . . . . . . . . . . . . . . . 1
Angle adjusting bracket B . . . . . . . . . . . . . . . . 1
Washer-fitted hexagonal bolts (M6 × 12) . . . 19
Washer-fitted screws (M4 × 10) . . . . . . . . . . . 5
Wire rope for ceiling mount bracket . . . . . . . 1
Flat wire clip for ceiling mount bracket . . . . . 2
Clamp tube for ceiling mount bracket . . . . . . 2
Wire rope for projector unit . . . . . . . . . . . . . . 1
*
Average value. May differ depending on models.
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
Description This ceiling mount bracket is to be used when mounting home cinema projectors to the ceiling.
C a u t i o n :
• All mounting work must be done by a qualified technician.
• Ensure that the mounting (ceiling) area has sufficient strength.
• Read the enclosed mounting instructions carefully before starting the mounting procedure.
• When the system is no longer to be used, have a qualified technician promptly remove and dispose of it.
• Do not use a power screwdriver or impact screwdriver to tighten screws. A torque screwdriver or similar tool
should be used.
3-∅ 9.5 (∅ 3/8)
∅8.5 (∅ 11/32 )
20 (2-9/16)
150 (5-29/32)
160 (6-5/16)
140 (5-1/2)
110 (4-11/32)
130 ( 5-1/8)
100 (3-15/16)
/