S P E C F I L E
ET-PKE16H
Ceiling mount bracket for high ceilings
As of September 2011
SFL11A018
1 / 1
Weights and dimensions shown are approximate. Specifications subject to change without notice.
889–1249
5°
5°
10°
10°
10°
10°
(35– 49-3/16)
Adjustable in
60 mm (2-3/8) steps
1172–1532
(146-5-32–60-5/16)
Adjustable in 60 mm (2-3/8) steps
428.5
∅ 70
(16-7/8)
386.5
25*
(31/32)*
650
(25-19/32)
A*
1
(15-7/32)
(2-3/4)
From center of
rotation to center
of lens
*
90
(3-17/32)
90
(3-17/32)
340
(13-3/8)
90
(3-17/32)
90
(3-17/32)
340
(13-3/8)
Projector
40
×
60
(1-9/16
×
2-3/8)
13
×
20
(1/2
×
25/32)
4–∅ 13 (∅ 1/2)
Specifications
Vertical correction angle: ±10°
Horizontal slant correction angle: ±5°
Horizontal turn correction angle: ±10°
Dimensions (W × H × D): 400 × 909–1,269 × 400 mm
(15-3/4˝ × 35-25/32˝– 49-31/32˝ × 15-3/4 ˝)
Weight: Approx. 17 kg* (37.5 lbs*)
Applicable bracket assembly: ET-PKE16B
The illustration shows the ceiling mount
bracket when it is combined with the
ET-PKE16B and the PT-EX16K is
attached.
Parts
Projector mount bracket A (pole included) . . . . . 1
Projector mount bracket B (pole included) . . . . . 1
Pole joint bolt . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Washer (M10) . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Hexagonal nut (M10) . . . . . . . . . . . . . . . . . . . . . 2
Snap pin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Screws (M5 × 10) . . . . . . . . . . . . . . . . . . . . . . . . 4
*
Average value. May differ depending on models.
unit : mm (inch)
NOTE: This illustration is not drawn to scale.
Dimensions
Description
This ceiling mount bracket is used when mounting a Panasonic projector to high ceilings.
NOTE: This ceiling mount bracket cannot be used by itself. Combine it with the optional ET-PKE16B bracket assembly.
C a u t i o n :
• Mounting should be done by a qualified technician.
• Make sure that the mounting (ceiling) area has sufficient strength.
• Read the enclosed mounting instructions thoroughly before starting.
• Do not use an electric screwdriver or impact driver to tighten screws. Use a torque driver or hexagon torque
wrench and tighten screws to the torque specified in the instructions.
• When the product is no longer going to be used, have it disposed of quickly by a professional disposal service.
/
