Anova RCPSC6 Assembly Instruction

Anova
Brand
Anova
Model
RCPSC6
Type
Assembly Instruction
anovafurnishings.com
888.535.5005 tel
ASSEMBLY INSTRUCTIONS
RCPSC6 6 Ft Recycled Plastic Plank Bench
TOOLS NEEDED:
18 volt (or higher) Drill with • 
T30 Torx Bit
24 X
1/4” x 3.0”
Torx Washer Head Screw
ASSEMBLY:
The assembly is a two-person operation.
1. Inspect the shipping container contents for damage and to determine that all components and hardware are present.
BENCH COMPONENTS:
8 X 2” x 4” Plank
ASSEMBLY HARDWARE:
3 X Bench Support
2. Place two of the Bench Supports about 2.5 feet apart.
3. Select one of the 2” x 4” Planks and position the Plank over the innermost sets of
predrilled holes in the Bench Supports. Make sure the clearance hole at the end of
the Plank aligns with the pilot hole in the Bench Support. Using the T30 Torx Bit,
drive one of the Washer Head Screws through the Plank clearance hole and into the
corresponding pilot hole in the Bench Support until tight.
Align the clearance hole in the middle of the Plank with the appropriate pilot hole in the
other Bench Support and install a Washer Head Screw using the Torx T30 Driver.
4. Place the remaining Bench Support under the other end of the Plank. Align the
clearance hole in the end of the Plank with the appropriate pilot hole in the last
Bench Support and install a Washer Head Screw using the Torx T30 Driver.
5. Align the clearance holes in another Plank with the uppermost set of pilot holes in the
Bench Supports and install Washer Head Screws.
6. Attach the rest of the Planks in the same manner, starting from the outside of the Bench
Supports and working inward, and from the top working down.
Do not drag the assembled unit across any surface.• 
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to • 
remove surface dirt. Do not clean with a solvent or petroleum based products.
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose, • 
missing, or broken hardware, and general instability.
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced. • 
Repairs must be made using only factory authorized parts and methods.• 
WARNING
CARE AND
MAINTENANCE
211 North Lindbergh Blvd.
St. Louis, MO 63141
tel: 888.535.5005
web: anovafurnishings.com
10/2012
  • Page 1 1

Anova RCPSC6 Assembly Instruction

Anova
Brand
Anova
Model
RCPSC6
Type
Assembly Instruction
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents