2. Aura
  3. CHOICE INTERIOR OPT7 LED Strip Lights
CHOICE INTERIOR OPT7 LED Strip Lights

Aura CHOICE INTERIOR OPT7 LED Strip Lights Installation guide

  • Hello! I've reviewed the Installation Guide for the OPT7 AURA CHOICE light strips. This document provides all the steps you need to install your new lights, from preparing the mounting surface to using the remote. I am ready to answer your questions about this product and its installation.
  • What should I do before mounting the LED strip?
    How do I power the light strips?
    How do I control the lights?
DISCLAIMER
NEED SUPPORT?
Scan for tutorial videos, troubleshooting tips,
and more.
OPT7 Lighting is not liable for damages or personal injuries while
installing this product. The Installation Guide is intended as assistance to
reduce setup time. OPT7 Lighting assumes no responsibility for
improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
INSTALLATION GUIDE
TM
CHOICE
MAIN COMPONENTS
CIGARETTE LIGHTER POWER ADAPTER HAND HELD REMOTE
AURA CONTROL KITS
OFFON
BLUEGREENRED
CYAN PURPLEYELLOWORANGE
FADE3 FADE7JUMP7JUMP3
1 2 3 4
WHITE
Light Bar: 8.85 x 0.55 x 0.36 inch
Light Strip Wire Length: 49.21 inch x 2 pc
68.89 inch x 2 pc
OPT7 recommends installation for safety and guidance.
Modied installations or installation recommendations not specied by OPT7
Lighting will void product warranty.
INTERIOR
INSTALLATION
Decide where to locate the light strips
and ensure wiring has enough length
for control box to be installed in
desired location.
STEP 1
Thoroughly clean the surface where you plan on mounting the LED strip with rubbing
/ isopropyl alcohol. (This part is essential for a rm and long lasting placement. A dirty
surface will prevent the strip from attaching rmly.)
Tear o the 3M Double-sided tape and rmly press the LED strip to the mounting area
and hold for 3 seconds.
CIGARETTE POWER ADAPTER12 VOLT CHARGING PORT
Once connected, plug the control box Cigarette Power Adapter into an available
12 volt charging port.
Secure control box in desired location.
But ensure that the protruding IR sensor and Sound sensor are placed in an direct
line of contact with the remote.
Ensure the control box is safely and securely hidden from exposing elements
of moisture.
3M
3M
Using the included E-Z Remote, select your desired color or pattern.
OFFON
BLUEGREENRED
CYAN PURPLEYELLOWORANGE
FADE3 FADE7JUMP7JUMP3
1 2 3 4
WHITE
Dimmer
Multi-Color Fade
Sound Sync
Multi-Color Jump
Adjust speed with "Dimmer" buttons Adjust speed with "Dimmer" buttons
Color Selection
On / Off
Sound sensor
IR sensor
STEP 2
STEP 3
STEP 4
/