2. OPT7
  3. Aura V1
Aura V1

OPT7 Aura V1 Installation guide

  • Hello! I've reviewed the OPT7 AURA Interior 6PC Installation Guide and am ready to assist you with your questions. The document contains important safety information and steps for setting up the interior lighting system, including connecting the light strips, using the control box, and operating the handheld remote. Feel free to ask me about any specific part of the installation or features.
  • What is the maximum amperage for the kit?
    What is the maximum operating temperature?
    Is the control box waterproof?
INTERIOR
6PC INSTALLATION GUIDE
LIGHT STRIPS
TM
MAIN COMPONENTS
AURA CONTROL BOX HAND HELD REMOTE
EXTENSION WIRES CIGARETTE LIGHTER POWER ADAPTER MOUNTING KIT
Y-SPLITTERS
Off
AUTO
On
S+
S-
M+
M-
321
INSTALLATION
Decide where to locate the light strips
and ensure wiring has enough length
for control box to be installed in
desired location.
STEP 1
Once connected, plug the control box Cigarette Power Adapter into an available
12 volt charging port.
CIGARETTE POWER ADAPTER12 VOLT CHARGING PORT
EXTENSION WIRE Y-SPLITTER
LIGHT STRIP
1.
2.
Connecting to more than 10 AMP will override the kit and cause early failure,
ensure it is 10AMPs or less!!
Please ensure that the LED bars or strips/control box/wiring all are mounted
in areas where will not exceed 85℃ or 185℉.
WARNING
As shown below, connect all light strips
to the control box with the included
extension cables.
INSTALLATION
Thoroughly clean the surface where you plan
on mounting the LED strip with rubbing /
isopropyl alcohol. (This part is essential for a
rm and long lasting placement.
A dirty surface will prevent the strip from attaching rmly.) Tear o the 3M Double-sided tape
and rmly press the LED strip to the mounting area and hold for 3 seconds.Then use the
ZIp-Ties to tie all wiring away from all moving components.
STEP 2
STEP 3
Secure Control box in desired location
with Velcro or zip ties.
* CONTROL BOX NOT WATERPROOF
Ensure the control box is safely and securely
hidden from exposing elements of moisture.
Using the included 21Key E-Z Remote, select your desired
color or pattern.
( Note: When you use this product, keep it within
10m/33ft as much as possible )
STEP 4
Off
AUTO
On
S+
S-
M+
M-
321
Power
Automatic Color Change
Power
Speed
Mode
Dimmer
Color Selection
SoundSYNC
ON
OFF
9 Levels
3 Modes
9 Levels
9 Colors
3 Modes
1 2 3
4
7
8
5 6
1
2
3
4
7
8
5
6
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this
product. The Installation Guide is intended as assistance to reduce setup time.
OPT7 Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket
upgrades, please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by
OPT7 Lighting will void product warranty.
/