2. Aura
  3. Choice Interior Strip Kit
Choice Interior Strip Kit

Aura Choice Interior Strip Kit Installation guide

  • Hello! I've reviewed the OPT7 user manual for the AURA CHOICE INTERIOR lighting system. This manual provides instructions on how to install the light strips and operate them using the included remote. The system itself has various color and pattern options. I'm ready to assist you with any questions you might have about using this product.
  • What should I do before mounting the LED strip?
    How do I power the control box?
    How do I operate the lights?
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries
while installing this product. The Installation Guide is intended
as assistance to reduce setup time. OPT7 Lighting assumes no
responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with
aftermarket upgrades, please seek professional assistance.
INSTALLATION GUIDE
TM
CHOICE
MAIN COMPONENTS
CIGARETTE LIGHTER POWER ADAPTER HAND HELD REMOTE
AURA CONTROL KITS
OFFON
BLUEGREENRED
CYAN PURPLEYELLOWORANGE
FADE3 FADE7JUMP7JUMP3
1 2 3 4
WHITE
Light Bar: 8.85 x 0.55 x 0.36 inch
Light Strip Wire Length: 49.21 inch x 2 pc
68.89 inch x 2 pc
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not
specified by OPT7 Lighting will void product warranty.
INTERIOR
INSTALLATION
Decide where to locate the light
strips and ensure wiring has
enough length for control box to
be installed in desired location.
STEP 1
Thoroughly clean the surface where you plan on mounting the LED strip with
rubbing / isopropyl alcohol. (This part is essential for a firm and long lasting
placement. A dirty surface will prevent the strip from attaching firmly.)
Tear off the 3M Double-sided tape and firmly press the LED strip to the
mounting area and hold for 3 seconds.
CIGARETTE POWER ADAPTER12 VOLT CHARGING PORT
Once connected, plug the control box Cigarette Power Adapter into an available
12 volt charging port.
Secure control box in desired location.
But ensure that the protruding IR sensor and Sound sensor are placed in an direct
line of contact with the remote.
Ensure the control box is safely and securely hidden from exposing elements
of moisture.
3M
3M
Using the included E-Z Remote, select your desired color or pattern.
OFFON
BLUEGREENRED
CYAN PURPLEYELLOWORANGE
FADE3 FADE7JUMP7JUMP3
1 2 3 4
WHITE
Dimmer
Multi-Color Fade
Sound Sync
Multi-Color Jump
Adjust speed with "Dimmer" buttons Adjust speed with "Dimmer" buttons
Color Selection
On / Off
Sound sensor
IR sensor
STEP 2
STEP 3
STEP 4
/