2. Aura
  3. DRL Halo RGB Dodge Challenger
DRL Halo RGB Dodge Challenger

Aura DRL Halo RGB Dodge Challenger Installation guide

  • Hello! I've reviewed the installation guide for the OPT7 DRL HALO RGB lighting system designed for the Dodge Challenger 08-22. This document outlines the components included, such as light strips, control box, remote and wiring, and provides step-by-step instructions on how to install the product. The guide also mentions important information regarding power consumption, operating temperature, and how to protect the system from water. I'm ready to assist with any questions you might have regarding this product or its installation.
  • What is the maximum amperage for the kit?
    What is the maximum operating temperature?
    Are the LED connectors waterproof?
    What car models are compatible with this lighting system?
INSTALLATION GUIDE
COMPONENTS
DRL HALO RGB
DODGE CHALLENGER 08-22
LIGHT STRIPS
AURA CONTROL BOX REMOTE
TM
MOUNTING KIT
EXTENSION WIRES
HARDWIRE POWER HARNESS
Open the hood.
INSTALLATION
Wrap the LED strip into a circle shape and firmly
press into place inside of the intake hole to secure.
Run the wires along the front brace and connect
to the control box.
Attach the strip as pictured as an alternate
method of install.
Remove the plastic covers on the right and left
side of the engine bay.
STEP 1 STEP 4
STEP 2
STEP 3
AND/OR
NOT
WATERPROOF
TM
Test for function.
STEP 6
STARTER
ENGINE
BLOCK
HARDWIRE
POWER
HARNESS
Connect the power wire harness to your
vehicle battery.
STEP 5
INSTALLATION
Heat Shrink Tube
1
2
* IMPORTANT:
The LED connectors are not waterproof.
You will need to use HEAT SHRINK TUBE
(not included) or ELECTRICAL TAPE
around the LED connectors to ensure
the longevity of the lighting kit.
EXAMPLE
AUXILIARY WIRE EXTENSION WIRE
TM
1.
2.
Connecting to more than 10 AMP will override the kit and cause early failure,
ensure it is 10AMPs or less!!
Please ensure that the LED bars or strips/control box/wiring all are mounted
in areas where will not exceed 85℃ or 185℉.
WARNING
FUSE
Dimmer
Color
Selection
Multi-Color Fade
Multi-Color Cycle
SoundSync™
Press multiple times to change color
Adjust speed with "Dimmer" buttons
Adjust speed with "Dimmer" buttons
Adjust speed with "Dimmer" buttons
Single-Color Strobe
On / Off
Press multiple times to change color
To adjust the sensitivity, please visit
www.OPT-7.com
Using the included E-Z Remote
or Keychain Remote to select
your desired color or pattern.
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to
https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
OPTIONAL UPGRADE
Upgrade your Aura Original Control Box
to the Aura Pro Bluetooth Control Box.
All new AURA Pro Bluetooth is App
enabled by a smartphone controller
(iOS & Android Compatible).
AURA PRO
BLUETOOTH CONTROL BOX
CONNECTED
ON
WHITE
RANDOM
BRIGHTNESS
SOLID
DOOR
ASSIST
OFF
DISCLAIMER
OPT7 Lighting is not liable for damages or personal injuries while installing this
product. The Installation Guide is intended as assistance to reduce setup time. OPT7
Lighting assumes no responsibility for improper installation.
If you are unfamiliar with your vehicle or inexperienced with aftermarket upgrades,
please seek professional assistance.
OPT7 recommends installation for safety and guidance.
Modified installations or installation recommendations not specified by OPT7
Lighting will void product warranty.
/