Focal Point ID+ 6" x 6" High Ceiling Wall Wash FL66H / L66H-SQ-WW Installation guide

Brand: Focal Point

Model: ID+ 6" x 6" High Ceiling Wall Wash FL66H / L66H-SQ-WW

Type: Installation guide

This manual is also suitable for

ID+ 6" x 6" High Ceiling Downlight FL66H / L66H-SQ-DN

IS0564 REV. B 2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 1 of 4

Luminaires must be installed by a qualied electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

id+ high ceiling 6" square

FL66H

key

power off power on

level attention

611/16” min

63/4” max

611/16” min

63/4” max

non-emergency

see additional instructions

LUMINAIRE MUST BE INSTALLED PRIOR TO DRYWALL CEILING.

ALL LUMINAIRES MUST BE SECURED TO STRUCTURE ABOVE.

emergency - remote test switch

downlight wall wash

REMOVE ZIP TIE

PRIOR TO INSTALLATION

5x4

WALL

wall wash orientation

trim

secure to structure aBove with 1/4 x 20

threaded rod or tiewire (By others)

GRID - 1/2" CONDUIT & CLIP (BY OTHERS)

LOOSEN SCREWS TO ADJUST HEIGHT OF HOUSING

IS0564 REV. B 2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 2 of 4

Fixtures must be installed by a qualied electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

DRYWALL

5X4

make electrical connections

8EMERGENCY

DO NOT MATE CONNECTOR

UNTIL INSTALLATION

IS COMPLETE AND A.C.

POWER IS SUPPLIED

release

indicator

from Bracket

prior to

installation

(JBOX SIDE)

3.68"

Ø.166"

(EDGE OF FLANGE TO CENTER OF HOLE)

secure to structure aBove with 1/4 x 20

threaded rod or tiewire (By others)

234a X2

X2X2

1/2" conduit By others

LOOSEN SCREWS TO ADJUST HEIGHT OF HOUSING

1/4" max

above ceiling

11D

SEE BATTERY MANUFACTURER

INSTRUCTIONS

emergency maximum mounting height:

35.00'

IS0564 REV. B 2016 ©Focal Point, LLC 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com 3 of 4

Fixtures must be installed by a qualied electrician (check with local and national codes for proper installation).

To prevent electrical shock, disconnect electrical supply before installation or servicing.

OPTIC ASSEMBLY

adjust indicator until

canopy is flush with ceiling

REMOVE TRIM

see trim removal ON

PAGE 4 OF INSTRUCTION SHEET

REVERSE STEPS

FOR INSTALLATION

OF OPTIC

DRIVER SERVICE

loosen wingnut

21 3

RAISE HEAT SINK FOR CLEARANCE

REMOVE TRIM

see trim removal ON

PAGE 4 OF INSTRUCTION SHEET

Contractor is responsible for adequately reinforcing walls and/or ceilings to support xture weight. Focal Point, LLC accepts no responsibility for inadequately reinforced walls and/or

ceilings. The information contained in this drawing is the sole property of Focal Point, LLC. Any reproduction in part or whole without the written permission of Focal Point, LLC

is prohibited.

DOWNLIGHT TRIM

1 3

WALL WASH

WALL

tighten wingnut

DOWNLIGHT WALL WASH

1 1

TRIM REMOVAL DO NOT PULL ON TRIM FLANGE