2. Focal Point
  3. ID+ 3.5" Pure Cylinder FLCY3N

Focal Point ID+ 3.5" Pure Cylinder FLCY3N Installation guide

  • Hello! I've reviewed the instructions for the Focal Point ID+ series cylinder luminaires, specifically models FLCY3N-RD-4H and FLCY3N-RD-7H. These instructions detail the installation process, including electrical connections, cord adjustments, and canopy assembly. I'm here to help answer your questions about the installation and components of these luminaires.
  • What type of J-box is required for installation?
    What should be done before installation or servicing?
    Who is responsible for reinforcing walls and ceilings?
©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
1 of 4
IS0827 REV. A
ID+ 3.5" Pure Cylinder - Cord Suspension
FLCY3N-RD-4H | FLCY3N-RD-7H- Mini Power Canopy
• Luminaires must be installed by a qualified
electrician (check with local and national
codes for proper installation).
• To prevent electrical shock, disconnect
electrical supply before installation or
servicing.
• Contractor is responsible for adequately
reinforcing walls and/or ceilings to support
fixture weight.
• Focal Point, LLC accepts no responsibility
for inadequately reinforced walls and/or
ceilings.
• The information contained in this drawing
is the sole property of Focal Point, LLC. Any
reproduction in part or whole without the
written permission of Focal Point, LLC is
prohibited.
POWER OFF
POWER ON
ATTENTION
SEE ADDITIONAL
INSTRUCTIONS
BEFORE YOU BEGIN COMPONENT KEY
INSTRUCTION KEY
3.55"
90.2mm
1.56"
39.6mm
3.50"
88.9mm
4.00"
101.6mm
" OCTAGONAL JBOX REQUIRED EMERGENCY
PRIOR TO LUMINAIRE INSTALLATION,
SEE PAGE  FOR EMERGENCY
INSTALLATION INSTRUCTIONS.
J-BOX BY OTHERS
MINI POWER
CANOPY
POWER CORD
MOUNTING
BRACKET
J-BOX MOUNTING
BRACKET /
DRIVER CARRIAGE
MINI POWER CANOPY
ID+ CYLINDER
7" HOUSING
HEIGHT
4" HOUSING
HEIGHT
FACE PLATE
FINISHING
RING
STRAIN RELIEF
2 of 4
IS0827 REV. A ©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
21
CANOPY ASSEMBLY SHIPS ASSEMBLED
12
48
567
9
X"
ADJUST
CORD
LENGTH
10 11
MAKE ELECTRICAL CONNECTION
TRIM CORD SHIELDING
TO TOP OF COLLAR
HOLD BY
CORD
13
INSTALL CANOPY
ASSEMBLY PARTS
SIMULTANEOUSLY
14
HAND TIGHTEN
ONLY
3
HARDWARE
BY OTHERS
MAKE ELECTRICAL CONNECTION
3 of 4
IS0827 REV. A ©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
DRIVER SERVICE
2
OPTIC SERVICE
1 32
TURN OFF POWER SOURCE
PRIOR TO DRIVER SERVICE
1
45X
DEPRESS TABS TO RELEASE OPTIC
67
USE ALIGNMENT GUIDES ON OPTIC ASSEMBLY
AND LED MODULE FOR PROPER INSTALLATION
4 of 4
IS0827 REV. A ©2023 Focal Point, LLC | 4141 S. Pulaski Rd., Chicago, IL 60632 | www.focalpointlights.com/reference
98 10
HAND TIGHTEN
ONLY
DO NOT OVER
TIGHTEN
11
EMERGENCY
1
SECURE TO STRUCTURE ABOVE
2
MAKE ELECTRICAL CONNECTION
SEE BATTERY MANUFACTURER
INSTRUCTIONS
EMERGENCY MAXIMUM MOUNTING HEIGHT:
CD & WH REFLECTORS  .'
WD & BK REFLECTORS  .'
HARDWARE
BY OTHERS
3 4
PROCEED TO
LUMINAIRE INSTALLATION
/