28mm Coffin with Target
B28-ST-106
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Coffin with Target (B28-ST-106)
Remove the four coffin pieces and the handles
from the sprue as shown above.
Carefully glue the handles into position as shown.
Take all the pieces of the coffin…
..and glue them together as shown above.
Glue the angled bracer to the back of the coffin.
Take the base and mausoleum sides from the sprue.
Glue the ends of the mausoleum to the base
using the holes/lugs provided, then attach the
two side pieces.
Next, take the decorative pieces from the sprue.
Glue the decorative pieces to the mausoleum as
shown.
Finally attach the top piece.
The coffin is attached to the base using the
angled bracket (as shown).
To make life easy, we suggest you paint both
sections of the model separately before attaching
the coffin to the base.
The finished model.
Painted example of the finished model.
/
