2. BLOTZ
  3. B28-ST-113

BLOTZ B28-ST-113 Assembly Instructions

  • I've reviewed the instructions for the Mausoleum B28-ST-113. This document provides a detailed guide to assemble the 28mm scale model. The instructions cover constructing the base, central column, walls and roof using PVA glue and other tools. I'm ready to answer any questions you have about the assembly process.
  • What type of glue is needed for assembly?
    What tools are needed for the assembly?
    Can I use pegs or elastic bands during assembly?
28mm Mausoleum
B28-ST-113
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
28mm Mausoleum (B28-ST-113)
Remove the pieces of the monument (see above) from
the sprue.
Stick the two base pieces together.
Glue the four pieces of the central column together.
Then stick the column to the base.
Add the top of the column….
..and then the two cap-stones.
Glue the monument to the space provided on the
mausoleum base as shown.
Remove the two end walls, gates and ridge piece
from the sprue.
Stick a set of gates to the back of each end piece, and
then glue the end pieces into the base using the
lugs/holes provided (see right). The ridge slots into
place between the two end pieces.
Glue the side walls into place.
Then add the end decoration…
...followed by the side decoration.
Finally add the two roof pieces, slotting them into the
holes provided.
/