ITC 81400 Series Installation guide

81400 Series
ITC
Brand
ITC
Model
81400 Series
Type
Installation guide
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
12V DC (+)
Black (-)
Drink
Holder
Black (-)
Red (+)
Incoming
12V DC
Power
PARTS/TOOLS NEEDED:
Drink Holders Butt Splice Connectors
(Not Provided) Power Drill Hole Saw Bit
Single Color Option
VersiColor RGB/RGBW Option
Determine the installation location and drill a 3-5/8” hole
using a hole saw (Note: For part #81427 & 81430 you will need
to drill a 4” hole).
1. If installing a standard drink holder proceed to step 3. If install-
ing a lit drink holder follow the wiring instructions below.
2.
If installing an adhesive mount drink holder, simply remove
the paper backing and press in place. If installing the screw
mount cup holder screw down using the provided screws. If
installing the blind mount, tighten screws until the tabs flip
out. Replace the decorative ring.
3.
Adhesive Mount Screw Mount
Blind Mount
Mounting
tabs
Black (-)
Drink
Holder
Incoming
12V DC
Power
RGB or RGBW
Controller
12V DC (+)
Black/Blue
Black/Green
Black/Red
Black/White*
White/Blue (+)
*Only the RGBW version will have the Black/White wire
Note: The 81433 USB drink holder has a 2.1A charging speed and
will come standard with DT connectors with the following pin posi-
tions:
Single Color RGBW
Slot 1: BK/BL Slot 3: BK/WH Slot 1: BK/RD Slot 4: WH/BL
Slot 2: BK/WH Slot 4: WH/BL Slot 2: BK/GR Slot 5: WH/BL
Slot 3: BK/BL Slot 6: BK/WH
INSTALLATION INSTRUCTIONS
Drink Holder
Part#: 81420, 81421, 81423, 81426, 81427,
81429, 81430, 81432 & 81433
For warranty information please visit www.itc-us.com/warranty-return-policy •
Rev B • 03/25/21
Page 1 of 1
  • Page 1 1

ITC 81400 Series Installation guide

81400 Series
ITC
Brand
ITC
Model
81400 Series
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents