2. ITC
  3. 69307

ITC 69307 Installation guide

  • I have reviewed the installation instructions for the ITC courtesy light model 69307. The document covers the necessary steps for proper installation, safety precautions, wiring diagrams for both single color and RGBW configurations, and lists required parts. I'm ready to answer your questions regarding this device.
  • What is the operating voltage for the light?
    Can this light be installed in wet locations?
    What wiring options are available?
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
1. Determine where your LED light fixture will be in-
stalled. Mark the location of the screw holes. Drill a
hole for the wires and screws.
Red (+)
Black (-)
Courtesy
Light
Red (+)
Black (-)
Incoming
12V DC
Power
Safety Instructions
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Light is rated for interior installation only, do not install in wet locations.
• Operating Voltage: 10 - 14V DC
2. Use the wiring diagram below to wire the light
to the units power. Test the light
3. Feed the wires through the hole and screw the
back nut onto the fixture. Snap bezel onto the
light.
PARTS NEEDED:
Courtesy Light Mounting Screws Power Drill Wire Nuts
(not provided)
RGBW Wiring
Red (-)
Black (+)
Courtesy
Light
Green (-)
Blue (-)
Incoming
12V DC
Power
RGBW
Controller
Red (+)Black (-)
White (-)
sold separately
Single Color Wiring
INSTALLATION INSTRUCTIONS
Down Courtesy Light
Part#: 69307
For warranty information please visit www.itc-us.com/warranty-return-policy
Rev B • 04/07/20
Page 1 of 1
/