ITC 69600 Installation guide

69600
ITC
Brand
ITC
Model
69600
Type
Installation guide
3030 Corporate Grove Dr.
Hudsonville, MI 49426
Phone: 616.396.1355
itc-us.com
1. Determine where your LED light fixture will be
installed. Once determined, drill a 2” hole using a
hole saw.
3. Use the wiring diagram below to wire the light to
the units power. Test the light.
PARTS NEEDED:
Courtesy Light Mounting Screws Power Drill w/ Hole Saw Bit Butt Splices
Safety Instructions
• Disconnect power before installing, adding or changing any component.
• To avoid a hazard to children, account for all parts and destroy all packing materials.
• Do not install any luminaire assembly closer than 6” from any combustible materials.
• It is recommended that fuse protection be added to the positive (+) input.
INSTALLATION INSTRUCTIONS
Cluster Courtesy Light
Part#: 69600
For warranty information please visit www.itc-us.com/warranty-return-policy
Rev A • 04/07/20
Page 1 of 1
Red (+)
Black (-)
Courtesy
Light
Red (+)
Black (-)
Incoming
12V DC
Power
Single Color Wiring
RGBW Wiring
Red (-)
Black (+)
Courtesy
Light
Green (-)
Blue (-)
Incoming
12V DC
Power
RGBW
Controller
Red (+)Black (-)
White (-)
sold separately
2. Mark location of screw holes and pre-drill. Screw
in fixture and snap bezel onto the light.
  • Page 1 1

ITC 69600 Installation guide

69600
ITC
Brand
ITC
Model
69600
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents