Energy Suspension 5.1101G5.1101G Operating instructions

Installation instructions:

1. Remove the bracket assembly from the vehicle.

2. Remove all of the old rubber from inside of the original shell before installing the New Energy Suspension

bushings. If heat is used to remove the old rubber, you need to only heat the outer shell enough to loosen the bond

of the old rubber. Do NOT burn out the bushing. Always use the proper protective/safety gear for the job and work

in a well ventilated area.

3. These "Hyperflex"tm replacement bushings were designed to fit the original equipment style outer shell with a

step on one side as indicated in the diagram above. If you have a Import manufactured bracket, and it has a

straight tube all the way through, you might have to grind a leading edge on the end of each bushing to get it

started. The import style has a slightly smaller I.D., but the soft "Hyperfex"tm bushing will compress and conform.

A vise works well in installing the new bushings.

17081

3/25/97KN

Updated 17/JAN/02 BRH

Set # 5-1101

Chrysler, Dodge and Plymouth transmission

mount Installation Instructions 1131 VIA CALLEJON, SAN CLEMENTE, CA 92673

Updated 13/DEC/01 BRH

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

Grind leading edge (Import

style) to help ease installation

Straight barrel

(part # 1022 engraved

on part)

Stepped barrel

(part # 1021 engraved

on part)

Supplied sleeve

.750”O.D. X .500”I.D. X 3.750” LG.

15.10.183.39

Download PDF