POSITION # 1
INST.# 17132
16/MAY/11 BRH
Must re-use original hardware.
Spray all nuts to be removed
generously with your favorite rust
buster.
Note: When disassembling, note the quantity
and positions of any shims that may have
been inserted for body alignment. These
shims will have to be reused to insure proper
body alignment.
Remember: Only raise body high enough to
remove & replace mounts. Always watch the
fan shroud for sufficient clearance when
raising the body. When jacking the body use a
long enough 2X4 or 4X4 for maximum
support. Never put jack directly on body
panels.
Install mounts one side at a time with bolts on
other side loosened only.
Retorque to factory specs.
Removal
Installation instructions
for set # 3-4141
4133
4134
2 1/2" O.D.x7/16"I.D.
washer
2" O.D.
washer
Frame
POSITION # 2,4,6,7
3/4" O.D
sleeve
2" O.D washer
3/4" O.D
sleeve
4134
4133
Body
Frame
Reuse
OEM shims
(may be more than one)
Front of Vehicle
2 1/2" O.D
washer
4131
2-1/2"O.D.x3/4"I.D.
Washer
Frame
4132
POSITION # 3
1" O.D
sleeve
2" O.D
washer
Body
POSITION # 5
Note: some vehicles did not
come with this bushing. (It is
located in a hole in front of
the upper rear spring perch.)
Body
4135
Frame
No sleeve, bolts or
washers are used in
this location
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
It is recommended that a factory
service manual be purchased prior
to performing any work on your car
or truck.
7
4
3
2
16
5
Front of Vehicle
Updated 8/JAN/03 BRH Updated 23/JAN/04 BRH
Updated 14/JAN/05 BRH Updated 10/JAN/06 BRH
Updated 2/JAN/07 BRH
2008 Energy Suspension. All rights reserved.2008 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.