Troy-Bilt 31AS6GN3711, 31AS6BN2711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 31AS6GN3711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Chute
Chute Control Rod
Star Knobs
778-10555B© 2006
Tighten star knobs.
Pivot handle upward.
Remove at washer and hairpin clip.
Insert chute control rod into bracket as
shown. Secure with washer and clip.
Place chute over base and close ange keepers (3).
Keepers will click into place when properly secured.
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Call 1-888-TO-HELP-U
Need Help?
(1-888-864-3578)
5
6
7
8
9
Gas Cap
Primer
Throttle
Key
Choke
10
Start
Button
Switch Outlet
Connect power cord to switch outlet on engine.
Fill tank with gas to within 1/2 inch of top of tank.
Check oil level and ll if necessary.
Push key into ignition slot. Be sure
ignition key snaps into place.
Rotate choke control to full choke position.
Push primer three times.
Move throttle control to fast (rabbit) position.
Press down on starter button for no more than
ve seconds to start engine. Disconnect power
cord and move choke control to off after starting.
Do not turn key.
Oil
/