Troy-Bilt 24A414B711 Fast Start Guide

  • Hello! I am an AI chatbot trained to assist you with the Troy-Bilt 24A414B711 Fast Start Guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
Remove spring
pin and clevis
pin from hitch
mounting base.
1
2
3
778-11421© 2007 24A-414B
Tow Bar
Chute Deflector
Hitch Mounting Base
Place opening of bag completely over chute deflector
and knobs.
Pull the drawstrap until the bag is tight around chute
deflector opening.
Insert tow bar
into base and
secure with
clevis pin and
spring pin.
Knobs
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2 inch of top of tank.
Need Help?
Call 1-800-800-7310
Move throttle on engine to FAST position.
(If engine is equipped with on/off switch, move switch to
ON position)
Fill engine with entire contents of oil bottle.
Use choke lever to choke engine.
Pull starter rope with quick, full armstroke. If engine does
not start after ten seconds of repeated pulls, wait a few
minutes and repeat this step. When engine starts, slowly
move choke to RUN position.
Gas Cap
Oil Fill
Throttle Control
Choke Control
Starter Rope
4
5
6
7
8
/