Troy-Bilt 24A424G711 Fast Start Guide

Type
Fast Start Guide
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Need Help? Call 1-888-TO-HELP-U (1-888-864-3578)
(A) Pull spring latch
upward.
(B) Pivot chipper chute
down until it clicks into
lock rod.
Remove spring
pin and clevis
pin from hitch
mounting base.
1
2
3
4
778-11420© 2007 24A-424G
Place opening of bag over the chute deflector and
knobs. Pull the drawstrap until the bag is tight around
chute deflector opening.
Insert tow bar
into base and
secure with
clevis pin and
spring pin.
B
A
Tow Bar
Chute Deflector
Hitch Mounting Base
Knobs
Chipper Chute
Lock Rod
Spring Latch
IMPORTANT: READ OPERATOR'S MANUAL AND ENGINE MANUAL THOROUGHLY AND
FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING .
Read and understand all instruction, warning, and danger labels.
Lea el manual de operación anexo sobre ensamblaje e inicio.
Fill tank with gas to within 1/2 inch of top of tank.
Need Help?
Call 1-800-800-7310
Move throttle on engine to FAST position.
(If engine is equipped with on/off switch, move switch to
ON position)
Fill engine with entire contents of oil bottle.
Use choke lever to choke engine.
Pull starter rope with quick, full armstroke. If engine does
not start after ten seconds of repeated pulls, wait a few
minutes and repeat this step. When engine starts, slowly
move choke to RUN position.
Gas Cap
Oil Fill
Throttle Control
Choke Control
Starter Rope
5
6
7
8
9
  • Page 1 1
  • Page 2 2

Troy-Bilt 24A424G711 Fast Start Guide

Type
Fast Start Guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI