Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Phillips screwdriver
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a Phillips screwdriver, remove the five (5) screws
from the side with the power switch.
Pull the cover off. Be careful not to damage the wires for
the charger port and power switch. Set cover aside.
POWER CORE E90 SPRINT BATTERY
REPLACEMENT PROCEDURES
PART # W20136401003
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3
Step 5
Step 4
Using a Phillips screwdriver, remove the two (2) screws
(on both sides of the battery) from the battery strap.
Remove battery strap and set aside.
Locate and disconnect the battery from the controller.
Remove the battery.
Reverse the steps
• Place the New Battery inside unit
• Re-connect the Battery and Control Module
• Place the Bracket back on the top of the battery
• Re-attach battery cover with screws.
ATTENTION: Charge battery 12 hours before using.
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Razor W13112144015 Operating instructions
-
-
Razor W15110710026 User manual
-
Razor Rambler User manual
-
Razor W15110710015 User manual
-
Razor W15110710048 User manual
-
Razor W15110710020 User manual
-
Razor W15127016106 User manual
-
-
Razor W13112163017, W13112144017 Power Core E90 Sprint Foot Platforms Replacement Operating instructions
